Thermoplastic-coated picnic tables combine the strength of commercial-grade picnic tables with the low-maintenance finish of thermoplastic-coated picnic tables. Whether you’ve invested in a round picnic table, a heavy-duty 8 ft picnic table, or a metal picnic table with an umbrella hole, keeping your outdoor furniture picnic table looking like new is simple when you follow these top care tips.
1. Clean Regularly with Gentle Solutions
-
Why it matters: Dirt, pollen, and spills can dull your weather-proof picnic tables and even trap moisture against the steel.
-
How to do it: Mix mild dish soap with warm water and wipe down your metal picnic tables for outdoors or picnic benches for outside using a soft cloth. Rinse with fresh water and air-dry (or towel-dry) to prevent water spots.
2. Protect Against UV & Rust
-
Why it matters: Even rubber-coated metal picnic tables for outdoors or aluminium epoxy coated picnic tables can fade under harsh sun or corrode in coastal air.
-
How to do it: Apply a UV-blocking spray or a car-wax-style protectant annually. Keep your commercial patio furniture and outdoor residential picnic tables covered when not in use.
3. Inspect & Touch Up Small Chips
-
Why it matters: Exposed steel on your outdoor picnic tables can rust quickly.
-
How to do it: Check the edges and corners of your composite picnic table or plastic-coated steel picnic tables every season. Lightly sand any bare spots, prime, then apply matching touch-up paint or spray.
4. Winterise & Store Properly
-
Why it matters: Freezing temperatures and salt melt can degrade even heavy-duty outdoor furniture and commercial park picnic tables.
-
How to do it: If possible, move your picnic and dining tables into a dry, sheltered area. Otherwise, cover completely with a breathable, waterproof cover rated for metal patio table protection.
5. Secure & Level on Installation
-
Why it matters: An unbalanced piece of playground furniture or picnic table with an umbrella hole can wobble, leading to premature wear.
-
Level It Right: When installing your picnic table—whether using inground sleeves or surface legs with expanding screws—place a bubble level on the tabletop and along the benches to confirm everything sits perfectly horizontal. Adjust leg positions before final tightening.
-
Anchor Securely: Tighten all mounting bolts to the manufacturer’s recommended torque. After bolting down, apply firm pressure at each corner of the metal picnic table (with or without backrest) to test for any wobble or play—readjust and retorque as needed.
-
Protect Exposed Hardware: Once installed, dab touch-up paint or a rust inhibitor around bolt heads and any scratched coating to seal exposed steel and keep your thermoplastic-coated picnic table weatherproof.
-
Spring Maintenance Check: At the start of each season, inspect all legs—inground and surface—for shifting or loosening. Re-torque every bolt, replace any worn washers, and top up protective coatings to maintain a lifetime picnic table’s stability and appearance.
With just a little regular attention, whether you own a round stainless steel picnic table, a thermoplastic-coated picnic table, or a commercial wood picnic setup, you can extend the life of your picnic table and enjoy countless meals under the sun. Treat your metal picnic table like the investment it is, and it will reward you with years of sturdy, low-maintenance service.